Motorola Solutions 자격증 MSC-122 시험덤프

우리ITExamDump에서는 끊임없는 업데이트로 항상 최신버전의Motorola Solutions인증MSC-122시험덤프를 제공하는 사이트입니다, 만약 덤프품질은 알아보고 싶다면 우리ITExamDump 에서 무료로 제공되는 덤프일부분의 문제와 답을 체험하시면 되겠습니다, ITExamDump 는 100%의 보장 도를 자랑하며MSC-122시험은 한번에 패스할 수 있는 덤프입니다.

여러분은 우리. ITExamDump의Motorola Solutions MSC-122시험자료 즉 덤프의 문제와 답만 있으시면Motorola Solutions MSC-122인증시험을 아주 간단하게 패스하실 수 있습니다.그리고 관련 업계에서 여러분의 지위상승은 자연적 이로 이루어집니다. ITExamDump의 덤프를 장바구니에 넣으세요. 그리고 ITExamDump에서는 무료로 24시간 온라인상담이 있습니다.

우리ITExamDump 는 많은IT전문가들로 구성되었습니다. 우리의 문제와 답들은 모두 엘리트한 전문가들이 만들어낸 만큼 시험문제의 적중률은 아주 높습니다. 거이 100%의 정확도를 자랑하고 있습니다. 아마 많은 유사한 사이트들도 많습니다. 이러한 사이트에서 학습가이드와 온라인서비스도 지원되고 있습니다만 우리ITExamDump는 이미 이러한 사이트를 뛰어넘은 실력으로 업계에서는 우리만의 이미지를 지키고 있습니다. 우리는 정확한 문제와답만 제공하고 또한 그 어느 사이트보다도 빠른 업데이트로 여러분의 인증시험을 안전하게 패스하도록합니다.Motorola Solutions MSC-122인증시험을 응시하려는 분들은 저희 문제와 답으로 안심하시고 자신 있게 응시하시면 됩니다. 우리ITExamDump 는 여러분이 100%Motorola Solutions MSC-122인증시험을 패스할 수 있다는 것을 보장합니다.

시험 번호/코드: MSC-122

시험 이름: Motorola Solutions (Deploy WLAN Solutions)

Motorola Solutions인증 MSC-122시험취득 의향이 있는 분이 이 글을 보게 될것이라 믿고ITExamDump에서 출시한 Motorola Solutions인증 MSC-122덤프를 강추합니다. ITExamDump의Motorola Solutions인증 MSC-122덤프는 최강 적중율을 자랑하고 있어 시험패스율이 가장 높은 덤프자료로서 뜨거운 인기를 누리고 있습니다. IT인증시험을 패스하여 자격증을 취득하려는 분은ITExamDump제품에 주목해주세요.

아무런 노력을 하지 않고 승진이나 연봉인상을 꿈꾸고 있는 분이라면 이 글을 검색해낼수 없었을것입니다. 승진이나 연봉인상을 꿈꾸면 승진과 연봉인상을 시켜주는 회사에 능력을 과시해야 합니다. IT인증시험은 국제적으로 승인해주는 자격증을 취득하는 시험입니다. ITExamDump의Motorola Solutions인증 MSC-122덤프의 도움으로 Motorola Solutions인증 MSC-122시험을 패스하여 자격증을 취득하면 승진이나 연봉인상의 꿈이 이루어집니다. 결코 꿈은 이루어질것입니다.

MSC-122 덤프무료샘플다운로드하기: http://www.itexamdump.com/MSC-122.html

NO.1 You are deploying a new WLAN within the WiNG 5 architecture. Which of the following is the only
UNSUPPORTED Motorola access point/port?
A. AP-300
B. AP-650
C. AP-5131
D. AP-7131
Answer: C

Motorola Solutions   MSC-122 dumps   MSC-122

NO.2 Your customer has requested that you configure unique VLANs for voice, normal user data with
802.1X security, guest access, and management traffic. Which of the following VLAN modes can support
this request?
A. Native Mode
B. Access Mode
C. Trunk Mode
D. Aggregation Mode
E. Encapsulation Mode
Answer: C

Motorola Solutions dumps   MSC-122기출문제   MSC-122 pdf   MSC-122   MSC-122

NO.3 If a Motorola access point induces a 50 mW RF signal onto a 3 dBi antenna, what will be the resulting
EIRP of the transmitted signal?
A. 0 dBm
B. 3 dBm
C. 20 dBm
D. 50 mW
E. 50 dBm
Answer: C

Motorola Solutions   MSC-122   MSC-122최신덤프   MSC-122 dump   MSC-122자료   MSC-122

NO.4 Which of the following statements regarding the configuration of Motorola RFS controllers is TRUE?
A. ADSP can be used to push CLI profiles to APs and controllers.
B. LANPlanner can be used to push CLI profiles to APs and controllers.
C. RFMS can be used to perform predictive site surveys using an RFS controller
D. WiNG 5 can be used to perform manual site surveys using an RFs controller
E. CLI can be used to perform both manual and predictive site surveys using an RFS controller.
Answer: A

Motorola Solutions인증   MSC-122덤프   MSC-122

NO.5 You are designing a WLAN that will support multiple BSS IDs. One of the characteristics you need to
take into consideration is that each BSS transmits a beacon every 100 ms. How many BSSs can be
enabled on the following Motorola access points under WiNG 5: AP7131, AP650, AP6532?
A. 2, one per radio
B. 1 per AP, it is shared between the radios to provide seamless roaming
C. 8, four per radio
D. 16, eight per radio
Answer: D

Motorola Solutions   MSC-122시험문제   MSC-122 pdf

NO.6 You are deploying a new system and are creating the RF Domain(s). Which of the following options
would you use to group the APs into the same domain?
A. By VLAN, where all APs are on the same subnet.
B. By site, which can be a location where the group of installed APs can hear each other's beacons.
C. By name, so they can be easily sorted in the tree view of the controller.
D. By deployment phase, so configurations can be accidentally pushed to newly installed APs.
Answer: A

Motorola Solutions   MSC-122최신덤프   MSC-122 dumps   MSC-122   MSC-122

NO.7 During a recent throughput analysis test of your 802.11g network, you discovered that performance is
poor in comparison to previous baselines. You discover that this is the result of 802.11b stations becoming
associated with your access point. What option could you implement to eliminate 802.lib clients from
attaching to your network?
A. Implement protection mechanisms
B. Make 24 mbps a required data rate
C. Implement RTS/CTS at the access point
D. Change the channel used for the network
Answer: B

Motorola Solutions기출문제   MSC-122   MSC-122   MSC-122기출문제

NO.8 You are performing a physical site survey of a new WiNG 5 WLAN deployment. Which of the following is
CORRECT?
A. The Signal to Noise Ratio (SNR) is a critical measurement that needs to be addressed.
B. It is acceptable that you use any RF infrastructure device (Access Point) to perform the site survey test.
C. Using default settings of a site survey application will provide an adequate site survey result.
D. Customer throughput requirements are the only criteria for which need to be surveyed.
Answer: B

Motorola Solutions   MSC-122   MSC-122

NO.9 Which of the following statements is NOT considered to be a best practice with respect to the wired
backbone serving the WLAN.?
A. When performing manual configuration of a point-to-point Ethernet link, ensure that both the speed and
the duplex mode settings on the two ports match.
B. When creating a link between Ethernet 10/100BASE-T or 10/100/1000BASE-T ports, enable (or accept
the default of) auto-negotiation on both ports.
C. When creating a link between Gigabit Ethernet fiber ports, enable (or accept the default of)
auto-negotiation.
D. When creating a link between Gigabit Ethernet fiber ports, disable auto-negotiation on both ports.
Answer: D

Motorola Solutions   MSC-122   MSC-122   MSC-122인증   MSC-122 dump

NO.10 Your customer has requested that during the upcoming 802.llg to 802.11n upgrade deployment you
enable 40 MHz channels on 1, 6, and 11 of the 2.4 GHz ISM band. You respond by saying that there is not
enough spectrum to allow 40 MHz channels centered on 1, 6, and 11. How wide are standard 802.11g
(OFDM) channels?
A. 20 MHz
B. 83.5 MHz
C. 5 MHz
D. 11 MHz
E. 22 MHz
Answer: A

Motorola Solutions dump   MSC-122   MSC-122

NO.11 You have configured a Motorola RFS controller using WiNG 5 and have attempted to adopt a group of
APs using L2 adoption but the adoption is not successful. You have confirmed the following:
-All of the APs have an Ethernet connection to the same LAN segment as the controller -Spanning Tree
Protocol (STP) has been disabled on the APs next hop switch port -Intermediate firewalls are not blocking
EtherType 0x8783
Given this scenario, which of the following is the most likely cause of the unsuccessful AP adoption?
A. DHCP option 192 has not been defined on the DHCP server
B. A local VLAN has been configured on both the controller and the APs
C. The APs GE ports have been configured for an S02.1q-tagged native VLAN
D. The APs GE ports have been configured for an 802.1q-untagged native VLAN
Answer: C

Motorola Solutions   MSC-122자료   MSC-122최신덤프   MSC-122

NO.12 Which of the following is the primary method of collision avoidance in an 802.11 CSMA/CA WLAN?
A. Backoff Timer
B. Carrier Sense
C. Contention Window
D. Enhanced Distributed Channel Access (EDCA)
E. Distributed Coordination Function Interframe Spaces (DIFS)
Answer: B

Motorola Solutions자료   MSC-122   MSC-122 pdf   MSC-122 dumps   MSC-122

NO.13 Which of the following APs does not support adaptive mode?
A. AP7131
B. AP6532
C. AP650
D. AP6521
Answer: A

Motorola Solutions자료   MSC-122덤프   MSC-122자료

NO.14 You have just conducted a throughput test using iPerf on a WLAN that shows a PHY signaling rate of 54
Mbps, however the average throughput rate shown in iPerf is only 23.5 Mbps. What is the most likely
explanation for this condition?
A. This throughput speed is considered nominal.
B. This throughput rate could indicate a mismatch between Wi-Fi confidentiality algorithms.
C. This throughput rate indicates excessive user activity.
D. This throughput rate indicates excessive out-of-band interference such as nearby cell phone towers.
Answer: A

Motorola Solutions인증   MSC-122   MSC-122덤프   MSC-122자료

NO.15 You have an access point that requires PoE connected to a switch with a 150 meter 10 BASE-T CAT 5
cable. During testing numerous problems with both data transmission and intermittent power occurs.
Which of the following is most likely the cause?
A. The cable should be CAT 6
B. There is a duplex mismatch
C. The cable should be 100 BASE-T
D. The cable is too long
Answer: D

Motorola Solutions   MSC-122   MSC-122최신덤프   MSC-122자격증   MSC-122

Motorola Solutions인증 MSC-122시험을 준비하기 위해 잠도 설쳐가면서 많이 힘들죠? ITExamDump덤프가 고객님의 곁을 지켜드립니다. ITExamDump에서 제공해드리는Motorola Solutions인증 MSC-122덤프는 실제Motorola Solutions인증 MSC-122시험문제를 연구하여 만든 공부자료이기에 최고의 품질을 자랑합니다. ITExamDump덤프를 열심히 공부하여 멋진 IT전문가의 꿈을 이루세요.