JN0-522 덤프 Juniper 자격증 덤프

목표가 있다면 목표를 향해 끊임없이 달려야 멋진 인생이 됩니다. 지금의 현황에 만족하여 아무런 노력도 하지 않는다면 언젠가는 치열한 경쟁을 이겨내지 못하게 될것입니다. IT업종에 종사중이시라면 다른분들이 모두 취득하는 자격증쯤은 마련해야 되지 않겠습니까? Juniper인증 JN0-522시험은 요즘 가장 인기있는 자격증 시험의 한과목입니다. IT업계에서 살아남으려면ITExamDump에서Juniper인증 JN0-522덤프를 마련하여 자격증에 도전하여 자기의 자리를 찾아보세요.

ITExamDump의 제품을 구매하시면 우리는 일년무료업데이트 서비스를 제공함으로 여러분을 인증시험을 패스하게 도와줍니다. 만약 인증시험내용이 변경이 되면 우리는 바로 여러분들에게 알려드립니다.그리고 최신버전이 있다면 바로 여러분들한테 보내드립니다. ITExamDump는 한번에Juniper JN0-522인증시험을 패스를 보장합니다.

ITExamDump의 Juniper인증 JN0-522덤프를 구매하시고 공부하시면 밝은 미래를 예약한것과 같습니다. ITExamDump의 Juniper인증 JN0-522덤프는 고객님이 시험에서 통과하여 중요한 IT인증자격증을 취득하게끔 도와드립니다. IT인증자격증은 국제적으로 인정받기에 취직이나 승진 혹은 이직에 힘을 가해드립니다. 학원공부나 다른 시험자료가 필요없이ITExamDump의 Juniper인증 JN0-522덤프만 공부하시면Juniper인증 JN0-522시험을 패스하여 자격증을 취득할수 있습니다.

시험 번호/코드: JN0-522

시험 이름: Juniper (FXV,Associate (JNCIA-FWV))

Juniper인증 JN0-522시험을 한방에 편하게 통과하여 자격증을 취득하려면 시험전 공부가이드가 필수입니다. ITExamDump에서 연구제작한 Juniper인증 JN0-522덤프는Juniper인증 JN0-522시험을 패스하는데 가장 좋은 시험준비 공부자료입니다. ITExamDump덤프공부자료는 엘리트한 IT전문자들이 자신의 노하우와 경험으로 최선을 다해 연구제작한 결과물입니다.IT인증자격증을 취득하려는 분들의 곁은ITExamDump가 지켜드립니다.

ITExamDump에서는 Juniper인증 JN0-522시험을 도전해보시려는 분들을 위해 퍼펙트한 Juniper인증 JN0-522덤프를 가벼운 가격으로 제공해드립니다.덤프는Juniper인증 JN0-522시험의 기출문제와 예상문제로 제작된것으로서 시험문제를 거의 100%커버하고 있습니다. ITExamDump제품을 한번 믿어주시면 기적을 가져다 드릴것입니다.

JN0-522 덤프무료샘플다운로드하기: http://www.itexamdump.com/jn0-522.html

NO.1 Assuming factory default settings, which statement describes the minimum requirements for WebUI
management access to the SSG 5?
A.Connect a PC addressed on the 192.168.1.0 subnet to any interface, open a browser and access
192.168.1.1.
B.Terminate the bootup sequence from the console device, open a browser on the console device and
access 192.168.1.1.
C.Connect a PC addressed on the 192.168.1.0 subnet, to the highest numbered interface and open a
browser and access 192.168.1.1.
D.Using the CLI, define an IP address on a physical interface, connect a PC to the interface and open a
browser to the interface address.
Answer:C

Juniper   JN0-522덤프   JN0-522   JN0-522시험문제   JN0-522

NO.2 What is the purpose of the "Permitted IP" address on a ScreenOS device?
A.It defines a list of addresses that are trusted to perform management on the ScreenOS device.
B.It is used in policy rules to determine which user traffic is allowed through the ScreenOS device.
C.It defines which range of addresses that can access devices connected to the ScreenOS device.
D.It is the address that an external device uses to gain management access to a ScreenOS device.
Answer:A

Juniper자격증   JN0-522   JN0-522자격증   JN0-522 dumps

NO.3 Click the Exhibit button. In the exhibit, which two forms of address translation would have generated
the output shown? (Choose two.)
A.MIP
B.NAT-src with no DIP
C.Interface-based translation
D.NAT-src with a DIP, fixed-port disabled
Answer:B C

Juniper   JN0-522   JN0-522

NO.4 Which command can you use to view the log of IKE negotiations and results?
A.get event type 536
B.get ike cookie
C.get sa active
D.debug ike basic
Answer:A

Juniper dumps   JN0-522   JN0-522   JN0-522

NO.5 Click the Exhibit button. In the exhibit, if host A initiates a Web browsing session with host D, and the
E0/1 interface of the SSG 20 is in NAT mode, what will be the source address of the packet arriving at
host D?
A.10.1.1.1
B.10.1.10.5
C.143.45.56.1
D.143.45.56.254
Answer:C

Juniper   JN0-522기출문제   JN0-522   JN0-522자격증   JN0-522최신덤프   JN0-522

NO.6 What are two benefits of configuring a ScreenOS device in transparent mode? (Choose two.)
A.There is no need to reconfigure the IP addresses of routers or protected servers.
B.There is no need to create MIPs or VIPs for incoming traffic to reach protected servers.
C.Policies are easier to create since you do not have to include source and destination IP addresses.
D.The product can support more VPNs and obtain greater throughput because there is less overhead to
manage.
Answer:A B

Juniper dumps   JN0-522 dump   JN0-522   JN0-522시험문제   JN0-522 dumps

NO.7 Click the Exhibit button. In the exhibit, which routing command would allow host A to communicate with
host C? (Note: Assume a route from the SSG 20 to host A's subnet already exists.)
A.set route 0.0.0.0/0 int e0/3 gateway 177.11.56.254
B.set route 1.1.70.0 interface e0/3 gateway 177.11.56.254
C.configure route 1.1.70.0/24 gateway 177.11.56.254 int e0/3
D.set route 1.1.70.0/24 interface e0/3 gateway 177.11.56.254
Answer:D

Juniper덤프   JN0-522   JN0-522   JN0-522

NO.8 Click the Exhibit button. In the exhibit, what is the correct command to configure a default route on the
SSG 20?
A.set route 0.0.0.0/0 vrouter untrust
B.set route 0.0.0.0/0 interface e0/4 gateway 143.45.56.254
C.set route 0.0.0.0/0 interface e0/4 next-hop 143.45.56.254
D.set route 0.0.0.0/0 interface 143.45.56.1 gate 143.45.56.254
Answer:B

Juniper   JN0-522   JN0-522   JN0-522   JN0-522   JN0-522

NO.9 Your VPN tunnel does not pass traffic. You run the get ike cookie command and discover that there is no
cookie. Which two should be verified? (Choose two.)
A.routes
B.Phase 1 configuration options
C.Phase 2 configuration options
D.selected quick mode encryption algorithms
Answer:A B

Juniper dumps   JN0-522자료   JN0-522 dump   JN0-522

NO.10 Which ScreenOS CLI command would be used to view traffic logs?
A.get traffic
B.get log policy
C.get policy log
D.get log traffic
Answer:D

Juniper   JN0-522자격증   JN0-522   JN0-522기출문제   JN0-522

NO.11 You enter the following command: set int e0/8 mip 1.1.8.32 host 10.1.10.32 netmask 255.255.255.255
How many MIP address translations have you just configured?
A.1
B.8
C.128
D.256
Answer:A

Juniper pdf   JN0-522자격증   JN0-522   JN0-522자료

NO.12 What is the purpose of the VLAN1 interface?
A.It provides policy-based NAT for 802.1Q VLANs.
B.It provides an interface that can be used with 802.1Q VLANs in transparent mode.
C.It provides the ScreenOS device with a routable IP address while operating in route mode.
D.It provides an interface that can be used to remotely manage the ScreenOS device while operating in
transparent mode.
Answer:D

Juniper자격증   JN0-522기출문제   JN0-522덤프   JN0-522

NO.13 What needs to be configured in Phase 2 of a route-based VPN, that does not need to be configured in a
policy-based VPN?
A.proxy-id
B.tunnel-binding
C.transport mode
D.custom proposals
Answer:B

Juniper기출문제   JN0-522자료   JN0-522   JN0-522최신덤프   JN0-522

NO.14 Which ScreenOS CLI command is required to enable a policy during specified times, days, or dates?
A.set time
B.set clock
C.set calendar
D.set scheduler
Answer:D

Juniper기출문제   JN0-522 dumps   JN0-522   JN0-522기출문제   JN0-522

NO.15 Click the Exhibit button. In the exhibit, what is the correct address book entry for host C?
A.set address C 1.1.70.250/32
B.set address Partner C 1.1.70.250
C.set address Partner 1.1.70.250/32
D.set address Partner C 1.1.70.250/32
Answer:D

Juniper   JN0-522덤프   JN0-522   JN0-522

NO.16 You want to minimize the number of IP addresses, subnets, and policies in use. How should you
configure your tunnel interface?
A.Configure the tunnel interface with an IP address with a 32 bit subnet mask.
B.Configure the tunnel interface with an IP address with a 30 bit subnet mask.
C.Configure the tunnel interface as unnumbered and place the interface in the same zone as the
designated interface.
D.Configure the tunnel interface as unnumbered, but place the tunnel interface in a different zone than the
designated interface.
Answer:C

Juniper   JN0-522   JN0-522   JN0-522   JN0-522

NO.17 Click the Exhibit button. Traffic from the Internet to the partner servers must use a VIP. In the exhibit,
what is true about the configuration of this feature?
A.You cannot use a VIP in this environment.
B.The VIP can be configured on the e0/4 interface.
C.The VIP can be configured in the Corporate or Internet zone using a different subnet than the physical
interface.
D.The VIP will work only if the destination ports in the incoming packet headers are mapped to the same
ports in the Corporate zone.
Answer:A

Juniper최신덤프   JN0-522최신덤프   JN0-522 dumps   JN0-522

NO.18 Which ScreenOS CLI policy statement keyword would enable a policy only during specified times, days,
and/or dates?
A.at
B.calendar
C.schedule
D.scheduler
Answer:C

Juniper덤프   JN0-522덤프   JN0-522

NO.19 Which ScreenOS CLI command would be useful for troubleshooting a policy deny?
A.get flow debug
B.debug flow basic
C.exec flow analysis
D.debug session basic
Answer:B

Juniper   JN0-522덤프   JN0-522   JN0-522   JN0-522기출문제

NO.20 Which statement is correct about tunnel interfaces?
A.They can have overlapping IP addresses.
B.They need to be configured in the zone where the protected resources reside.
C.They can be unnumbered and used in policy-based translations if the interface is in route mode.
D.They can be unnumbered from any interface residing on the same virtual router as the protected
resources.
Answer:D

Juniper pdf   JN0-522시험문제   JN0-522최신덤프

ITExamDump에서 Juniper인증 JN0-522덤프를 구입하시면 퍼펙트한 구매후 서비스를 제공해드립니다. Juniper인증 JN0-522덤프가 업데이트되면 업데이트된 최신버전을 무료로 서비스로 드립니다. 시험에서 불합격성적표를 받으시면 덤프구매시 지불한 덤프비용은 환불해드립니다.