ITExamDump는 IT업계에서 유명한 IT인증자격증 공부자료를 제공해드리는 사이트입니다. 이는ITExamDump 의 IT전문가가 오랜 시간동안 IT인증시험을 연구한 끝에 시험대비자료로 딱 좋은 덤프를 제작한 결과입니다. CheckPoint인증 156-315.71덤프는 수많은 덤프중의 한과목입니다. 다른 덤프들과 같이CheckPoint인증 156-315.71덤프 적중율과 패스율은 100% 보장해드립니다. CheckPoint인증 156-315.71시험에 도전하려는 분들은ITExamDump 의CheckPoint인증 156-315.71덤프로 시험을 준비할것이죠?
156-315.71는CheckPoint의 인증시험입니다.156-315.71인증시험을 패스하면CheckPoint인증과 한 발작 더 내디딘 것입니다. 때문에156-315.71시험의 인기는 날마다 더해갑니다.156-315.71시험에 응시하는 분들도 날마다 더 많아지고 있습니다. 하지만156-315.71시험의 통과 율은 아주 낮습니다.156-315.71인증시험준비중인 여러분은 어떤 자료를 준비하였나요?
시험 번호/코드: 156-315.71
시험 이름: CheckPoint (Check Point Certified Security Expert R71)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 480 문항
업데이트: 2014-03-23
ITExamDump의CheckPoint인증 156-315.71시험대비 덤프는 가격이 착한데 비하면 품질이 너무 좋은 시험전 공부자료입니다. 시험문제적중율이 높아 패스율이 100%에 이르고 있습니다.다른 IT자격증에 관심이 있는 분들은 온라인서비스에 문의하여 덤프유무와 적중율등을 확인할수 있습니다. CheckPoint인증 156-315.71덤프로 어려운 시험을 정복하여 IT업계 정상에 오릅시다.
ITExamDump의CheckPoint인증 156-315.71덤프공부가이드에는CheckPoint인증 156-315.71시험의 가장 최신 시험문제의 기출문제와 예상문제가 정리되어 있어CheckPoint인증 156-315.71시험을 패스하는데 좋은 동반자로 되어드립니다. CheckPoint인증 156-315.71시험에서 떨어지는 경우CheckPoint인증 156-315.71덤프비용전액 환불신청을 할수 있기에 보장성이 있습니다.시험적중율이 떨어지는 경우 덤프를 빌려 공부한 것과 같기에 부담없이 덤프를 구매하셔도 됩니다.
156-315.71 덤프무료샘플다운로드하기: http://www.itexamdump.com/156-315.71.html
NO.1 Organizations are sometimes faced with the need to locate cluster members in different geographic
locations that are distant from each other. A typical example is replicated data centers whose location is
widely separated for disaster recovery purposes.
What are the restrictions of this solution?
A. There are no restrictions.
B. There is one restriction: The synchronization network must guarantee no more than 150 ms latency
(ITU Standard G.114).
C. There is one restriction: The synchronization network must guarantee no more than 100 ms latency.
D. There are two restrictions: 1. The synchronization network must guarantee no more than 100ms
latency and no more than 5% packet loss. 2. The synchronization network may only include switches and
hubs.
Answer: D
CheckPoint최신덤프 156-315.71덤프 156-315.71 156-315.71자료 156-315.71
NO.2 Check point Clustering protocol, works on:
A. UDP 8116
B. UDP 500
C. TCP 8116
D. TCP 19864
Answer: A
CheckPoint자격증 156-315.71덤프 156-315.71시험문제 156-315.71 dumps 156-315.71자료
NO.3 Refer to Exhibit:
Match the ClusterXL Modes with their configurations
A. A-3, B-2, C-1, D-4
B. A-3, B-2, C-4, D-1
C. A-2, B-3, C-4, D-1
D. A-2, B-3, C-1, D-4
Answer: C
CheckPoint 156-315.71최신덤프 156-315.71 156-315.71자료 156-315.71최신덤프
NO.4 Which of the following statements about the Port Scanning feature of IPS is TRUE?
A. The default scan detection is when more than 500 open inactive ports are open for a period of 120
seconds.
B. The Port Scanning feature actively blocks the scanning, and sends an alert to SmartView Monitor.
C. Port Scanning does not block scanning; it detects port scans with one of three levels of detection
sensitivity.
D. When a port scan is detected, only a log is issued, never an alert.
Answer: C
CheckPoint 156-315.71기출문제 156-315.71자격증 156-315.71
NO.5 Which of the following manages Standard Reports and allows the administrator to specify automatic
uploads of reports to a central FTP server?
A. Smart Dashboard Log Consolidator
B. Security Management Server
C. Smart Reporter Database
D. Smart Reporter
Answer: D
CheckPoint자격증 156-315.71 pdf 156-315.71자료 156-315.71
NO.6 You want to verify that your Check Point cluster is working correctly. Which command line tool can you
use?
A. cphaconf state
B. cphaprob state
C. cphainfo-s
D. cphastart -status
Answer: B
CheckPoint 156-315.71 156-315.71자격증
NO.7 John is configuring a new R71 Gateway cluster but he can not configure the cluster as Third Party IP
Clustering because this option is not available in Gateway Cluster Properties: What's happening?
A. John is not using third party hardware as IP Clustering is part of Check Point's IP Appliance B .Third
Party Clustering is not available for R71 Security Gateways.
B. ClusterXL needs to be unselected to permit 3rd party clustering configuration.
C. John has an invalid ClusterXL license.
Answer: C
CheckPoint자료 156-315.71 dump 156-315.71최신덤프 156-315.71기출문제 156-315.71덤프 156-315.71시험문제
NO.8 What is a task of the SmartEvent Correlation Unit?
A. Add events to the events database.
B. Look for patterns according to the installed Event Policy.
C. Assign a severity level to an event
D. Display the received events.
Answer: B
CheckPoint dump 156-315.71 156-315.71 156-315.71 156-315.71
NO.9 Which external user authentication protocols are supported in SSL VPN?
A. LDAP, Active Directory, SecurID
B. DAP, SecurID, Check Point Password, OS Password, RADIUS, TACACS
C. LDAP, RADIUS, Active Directory, SecurID
D. LDAP, RADIUS, TACACS, SecurID
Answer: B
CheckPoint 156-315.71자격증 156-315.71 dumps 156-315.71자격증 156-315.71 dumps
NO.10 You are establishing a ClusterXL environment, with the following topology: External interfaces
192.168.10.1 and 192.168.10.2 connect to a VLAN switch. The upstream router connects to the same
VLAN switch. Internal interfaces 172.16 10.1 and 172.16.10.2 connect to a hub. 10.10.10.0 is the
synchronization network. The Security Management Server is located on the internal network with IP
172.16.10.3. What is the problem with this configuration?
A. There is an IP address conflict
B. The Security Management Server must be in the dedicated synchronization network, not the internal
network.
C. The Cluster interface names must be identical across all cluster members.
D. Cluster members cannot use the VLAN switch. They must use hubs.
Answer: B
CheckPoint 156-315.71 156-315.71자격증
NO.11 ________is a proprietary Check Point protocol. it is the basis for Check Point ClusterXL inter-module
communication.
A. RDP
B. CCP
C. CKPP
D. HA OPCODE
Answer: B
CheckPoint 156-315.71 156-315.71 156-315.71기출문제 156-315.71최신덤프
NO.12 Which procedure creates a new administrator in SmartWorkflow?
A. Run cpconfig, supply the Login Name. Profile Properties, Name, Access Applications and Permissions.
B. In SmartDashboard, click SmartWorkflow / Enable SmartWorkflow and the Enable SmartWorkflow
wizard will start. Supply the Login Name, Profile Properties, Name, Access Applications and Permissions
when prompted.
C. On the Provider-1 primary MDS, run cpconfig, supply the Login Name, Profile Properties, Name,
Access Applications and Permissions.
D. In SmartDashboard, click Users and Administrators right click Administrators / New Administrator and
supply the Login Name. Profile Properties, Name, Access Applications and Permissions.
Answer: D
CheckPoint pdf 156-315.71기출문제 156-315.71 dumps
NO.13 Control connections between the Security Management Server and the Gateway are not encrypted by
the VPN Community. How are these connections secured?
A. They are encrypted and authenticated using SIC.
B. They are not encrypted, but are authenticated by the Gateway
C. They are secured by PPTP
D. They are not secured.
Answer: D
CheckPoint 156-315.71 156-315.71
NO.14 Which of the following is NOT a feature of ClusterXL?
A. Enhanced throughput in all ClusterXL modes (2 gateway cluster compared with 1 gateway)
B. Transparent failover in case of device failures
C. Zero downtime for mission-critical environments with State Synchronization
D. Transparent upgrades
Answer: C
CheckPoint dumps 156-315.71 156-315.71
NO.15 How does a cluster member take over the VIP after a failover event?
A. Ping the sync interface
B. if list -renew
C. Broadcast storm
D. Gratuitous ARP
Answer: D
CheckPoint dump 156-315.71 156-315.71덤프 156-315.71 pdf 156-315.71덤프
NO.16 You are MegaCorp Security Administrator. This company uses a firewall cluster, consisting of two
cluster members. The cluster generally works well but one day you find that the cluster is behaving
strangely. You assume that there is a connectivity problem with the cluster synchronization cluster link
(cross-over cable).
Which of the following commands is the best for testing the connectivity of the crossover cable?
A. telnet <IP address of the synchronization interface on the other cluster member>
B. arping <IP address of the synchronization interface on the other cluster member>
C. ifconfig a
D. Ping <IP address of the synchronization interface on the other cluster member>
Answer: B
CheckPoint 156-315.71 dumps 156-315.71 156-315.71 dump 156-315.71 dumps
NO.17 What command will allow you to disable sync on a cluster firewall member?
A. fw ctl setsync 0
B. fw ctl sysnstat stop
C. fw ctl sysnstat off
D. fw ctl setsyns off
Answer: D
CheckPoint 156-315.71 156-315.71최신덤프
NO.18 You need to publish SecurePlatform routes using the ospf routing protocol. What is the correct
command structure, once entering the route command, to implement ospf successfully?
A. Run cpconfig utility to enable ospf routing
B. ip route ospf
ospf network1
ospf network2
C. Enable
Configure terminal
Router ospf [id]
Network [network] [wildmask] area [id]
D. Use DBedit utility to either the objects_5_0.c file
Answer: C
CheckPoint 156-315.71 156-315.71덤프 156-315.71
NO.19 Which of the following commands can be used to stop Management portal services?
A. fw stopportal
B. cpportalstop
C. cpstop / portal
D. smartportalstop
Answer: D
CheckPoint기출문제 156-315.71 156-315.71 156-315.71
NO.20 When you check Web Server in a host-node object, what happens to the host?
A. The Web server daemon is enabled on the host.
B. More granular controls are added to the host, in addition to Web Intelligence tab settings.
C. You can specify allowed ports in the Web server's node-object properties. You then do not need to list
all allowed ports in the Rule Base.
D. IPS Web Intelligence is enabled to check on the host.
Answer: B
CheckPoint시험문제 156-315.71자료 156-315.71 156-315.71 pdf 156-315.71
ITexamdump의 MB5-700덤프의 VCE테스트프로그램과 200-101덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 CV0-001시험에 대비한 고품질 덤프와 C4060-155시험 최신버전덤프를 제공해드립니다. 최고품질 000-303시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기